Gas Fireplace Won't Start But Pilot Light Is On. The actual reason for why your pilot light won’t stay lit can be a pretty complex one (try reading the paragraphs above without your eyes glazing over)… because of this, we recommend contacting your local chimney and fireplace professionals before trying to fix these issues yourself. With the gas on, push in and hold the pilot valve while igniting the pilot light.
If the receiver gets defective, the gas valves will not receive the signals. The gas fireplace pilot light is out. If gas is coming out of the pilot, but it still won't light, the spark igniter could be the problem.
The Pilot, Found As Part Of The Ignition, Can Often Be Seen When Looking Down From Above Within The Firebox Or Below Through The Control Area.
With the gas on, push in and hold the pilot valve while igniting the pilot light. So you’ve checked your pilot light and even reset it, but still, it wont stay lit. If the receiver gets defective, the gas valves will not receive the signals.
At This Point, The Pilot Light Should Continue To Burn.
This is another relatively small piece of your fireplace that converts heat to electricity, ultimately opening the gas valve when you turn on the fireplace. Why is my gas fireplace making a noise? If your fireplace has a conventional pilot light:
Call Your Gas Service Provider To Check That Your Account Is Up To Date.
Consequently, your valor gas fireplace won’t light. However, there may be unusual noises caused by external. Where is the pilot light on a gas fireplace?
In Simple Words, The Gas Valves Remain Closed, And No Gas Will Go To The Pilot.
Pilot light to gas fireplace won’t stay lit. A pilot light that doesn’t glow blue is also a problem, as this means it is not getting hot enough. Then, it transfers this signal to the gas valves.
A Stuck Valve Or A Issue With The Gas Regulator At Your Tank Will Reduce The Reliability Of Your Fireplace.
Shut off the fireplace, ensure your home is vented and call your gas company or a professional technician. My gas fireplace won’t light, but i have a spark at the ignitor, what do i do? Wait 30 seconds before you release the gas control knob.